Foetsie opens soon. Build your set and see the price now.Orders open when the first print run starts.

Soft rubber feet for furniture

Feet for your furniture, made to fit.

Tell us the size of your table or chair legs. We print soft rubber feet to that exact size, so your furniture stops scratching the floor and stops wobbling.

Build your set

A set of four from R95

A light oak table leg on a wooden floor, wearing a snug charcoal rubber foot
Square, charcoal42 × 42 mm

Watch

Foetsie in under a minute

Curved scratches on a pale wooden floor around the bare metal foot of a chair leg

Why made to fit

Shop-bought pads almost never fit your legs.

  • Felt pads come in a few sizes, peel off within weeks and leave the hard edge of the leg on the floor.

  • A Foetsie foot is a soft cup printed to your measurement, so it grips the leg and stays on without glue.

  • Odd shapes are fine: tapered legs, rectangular legs and old metal tubes. For anything unusual, send us your idea and we will quote you.

How it works

From your measurement to your floor

  1. 1

    Measure

    Measure across the bottom of one leg with a ruler or tape. Write it down in millimetres.

  2. 2

    Choose

    Pick the shape, the colour and how many feet you need.

  3. 3

    Order

    Send us your set. We check the size and send you a secure payment link. Paid sets join the next print run.

  4. 4

    Slip them on

    We print your feet, check them against your size and send them to you.

A chair turned upside down, with a steel ruler held across the end of one leg to measure it A wooden kitchen chair on a tiled floor, each leg wearing a snug yellow rubber foot

Your set

Build your set

We print every week. Prices may change a little before orders open.

Shape of the leg
Size at the bottom of the legMeasure where the leg touches the floor. Anything from 12 to 90 mm.
mm
Colour
How many feet
4 Sets start at 4. Extra feet R22 each.
Getting them to you
Your details

Your foot, seen from aboveactual size

Drawing of your foot

4 feetR95
Pickup pointR60

TotalR155

If they don't fit because we got it wrong, we reprint them for free.

Questions

Before you order

Nine rubber foot caps in round, square and rectangular shapes, in black, grey, white, clear, brown and yellow
What are they made of?

A soft, bendy plastic rubber called TPU, at a hardness of 95A on the Shore scale. That is the same family of material used for flexible phone covers. It grips the leg, does not mark tiles or wooden floors, and does not go hard in the sun.

How exact must my measurement be?

Within a millimetre is best. We print the inside of the cup half a millimetre smaller than your measurement so it holds on firmly. If you are unsure, measure two legs and send the bigger number.

My legs get narrower towards the floor. Will that work?

Yes. Measure right at the bottom, where the leg touches the floor. The cup is 15 mm deep and stretches enough to follow a gentle taper.

When do I pay?

After we have checked your size, we send you a secure payment link by card or instant EFT. Every set is made for one customer, so we print only sets that have been paid for.

My legs are an odd shape, or I have my own idea. Can you help?

Very likely. Choose "Something else" when you build your set and tell us about it: oval or angled legs, hairpin legs, metal tubes, castors, or feet for something that isn't furniture at all. Send a photo with a ruler next to the leg if you can. We look at every request and come back to you with a quote before anything is printed.

What if they don't fit?

If the size is our mistake, we reprint them for free. If the measurement was off, we reprint them at half price. Send us a photo of the foot on the leg and we will sort it out.